So Veegum (2%) and tragacanth (0.75%) were used in all blend formulations, but CMC and PVP in different formulations were changed. Nag in 2005 studied the stability and flow behavior of barium sulphate suspensions in the presence of various polymers such as PVP. Results showed that PVP had no significant effect on sedimentation volume [10]. F and n values

of the suspensions of different structural vehicles and flocculating agent are shown in Table 2. The suspending agents alone were not able to suspend particles, while their combination showed BLZ945 manufacturer excellent results. According to the results of the ease Inhibitors,research,lifescience,medical of redispersion, formulations F8 and F11 with the concentration of 0.04% NaCl were not able to disperse ideally. Table 2 The value of sedimentation volume (F) and ease of redispersion (n) for acetaminophen suspension in different formulations

(mean ± SD n = 4). The values of N as an indicator for defining the type of flow for different formulations are presented in Table 3. In Newtonian fluids, shear stress and shear rate are directly proportional (N = 1), so the rheogram will be Inhibitors,research,lifescience,medical a straight line, while, in non-Newtonian fluids, there is not a direct relationship between them (N > 1) [17]. Inhibitors,research,lifescience,medical Dilatant systems are inverse of that possessed by pseudoplastic systems (N < 1) [4]. According to the values of N, all formulations showed pseudoplastic behavior. The important parameter for predicting flow behavior of liquid dispersion is the area of the hysteresis Inhibitors,research,lifescience,medical loop, which is shown in Table 3. Evaluation of hysteresis area revealed that all of the formulations except formulations F8 and F11 had thixotropy behavior. It is generally accepted that greater hysteresis area leads to stronger thixotropic property, and a good suspension should have a relatively high pseudoplastic behavior and some degree of thixotropy [18]. Table 3 Indicator for defining the type of rheological behavior (N), hysteresis loop, and pseudoplastic viscosity at 30rpm (η30) in different formulations. In formulations F9–F11 all suspending agents were used. The value of hysteresis loop and apparent viscosity

in formulation F9 without NaCl were 279.9dyne·cm·min−1 Inhibitors,research,lifescience,medical and 564.05cp, respectively (P < 0.05). At low concentrations of NaCl (0.02%), the value of hysteresis loop and apparent viscosity of Resminostat formulation F10 increased (Figure 1 and Table 3) (P < 0.05). In formulation F11 with high concentration of NaCl (0.04%), the apparent viscosity of suspension was drastically rinsed so that the instrument could not show any value for torque. Figure 1 Rheograms and thixotropy of acetaminophen suspensions in formulations (a) F7, (b) F10, and (c) F13. Regarding above mentioned results, presence of NaCl in formulations F10 and F11 increased the apparent viscosity in comparison with formulation F9 (without NaCl). Suspension F6 is the same as F9, but it did not contain CMC in its formulation. The value of hysteresis loop and apparent viscosity of F6 was 286dyne·cm·min−1 and 290.93cp, respectively.